I will try to make it short.. I have a building that is multifloor, but all cable pulls come to 1 closet. Here I have about (24) 2924's. What I am trying to do is figure out where each port on the 2924's go to. They just about all go to a workstation, so it would be nice is I could run something and it would give me the Mac address of end station or Net Bios Name or even IP. Can someone point me into the proper direction on how to figure this out...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...