Re: How do you calculatate bandwidth used by one application ?
You might want to try using NBAR- network based app. recognition. its not supported in all router platforms. Needs CEF to be supported and enabled on the router. (typically starting from 2600, u can use NBAR). This feature helps in classification of traffic according to protocol type and collects statistics of each protocol flow.
ip nbar protocol-discovery is the command to be enabled under the router interface, and show ip nbar protocol-discovery should indicate the statistics of each protocol, 5 minute bit rate (bps) (both inbound and outbound) on that interface. You ll also get the packet count and byte count information for each protocol. Check out nbar feature for more details on what all protocols are supported. als new protocols can be supported by loading modules available from Cisco for download.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...