Re: How do you configure/verify QoS on a 2950 switch ?. 802.1P C
Have you used the "mls qos cos overide" interface command? Without this, the default marking will occur (cos 0). If you have a port that you know will be just a cisco phone and nothing else, you could use the "mls qos trust device cisco-phone" interface command. The cisco phone already marks voice packets with cos of 5 and call signaling packets with cos of 3. Since you are using an SI 2950, the cos to dscp mapping for voice is not correct (by default). cos values of 5 are mapped to DSCP 40 on a 2950. To get around this, you can use a mutation map on a higher end switch or router to match and reclassify. Hope this helps.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.