Re: How is the mac for the rootbridge chosen on a Cat5000?
On a catalyst 6000 running in the hybrid mode, the command is the same as on the cat5000. On a catalyst 6000 running in the integrated IOS mode the command is "sh catalyst6000 chassis-mac-addresses".
For the cat4000 supervisor I (WS-X4012) and supervisor II (WS-X4013) these mac-addresses come from the supervisor module rather than from the chassis. So, you can get them from the show module command. Look at the mac-addresses associated with module 1. For the cat4000 supervisor III (WS-X4014) and supervisor IV (WS-X4015), you can get them from the command "show idprom chassis". Look at the output of MAC Base=.
Finally, for the Catalyst 2900XL/3500XL switches you can look at the output of "show version". Scroll down to where it reads Base Ethernet MAC-Address:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.