How many CW2K machines are necessary to run LMS 2.1 + RWAN 1.2 ?
I know that theoretically it is possible to install everything on one machine. On the other, there are recommendations that certain parts of the software should not be installed on the same system. E.g. one had better install RTM on a machine different from CW2K. Same is true for VHM as far as i know.
But what about the rest? ACLM must run on the same machine as RME. But IPM must not if SSH/SSL shall be used. What else?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...