Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How To Add IP Address to Native VLAN1 on Router?

How does one assign an IP address to the Native VLAN (VLAN1) on a 2948G-L3?

1 REPLY
Cisco Employee

Re: How To Add IP Address to Native VLAN1 on Router?

Your question is not very clear. Are you talking about native VLAN on a dot1q trunk? If so, use the keyword native under the sub-interface as shown below

interface GigabitEthernet49

no ip address

no ip directed-broadcast

!

interface GigabitEthernet49.1

encapsulation dot1Q 1 native<<<<<<<<<<<------

ip address 10.1.1.1 255.255.255.0

no ip directed-broadcast

!

interface GigabitEthernet49.2

encapsulation dot1Q 2

ip address 20.1.1.1 255.255.255.0

no ip directed-broadcast

102
Views
0
Helpful
1
Replies