Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

How to busyout a channel on a certain PRI and timout settings.

I have just installed an AS5400 w/ 216 modems and 1 CT3 card and an 8 PRI card. I want to know how to busy out channels on the PRI card. So I will be able to test the failover of PRI's. Also the last problem I'm having is when a user dial's in they get disconnected after a couple of minutes, where to I set the timer for connection time?

Thanks for your help in advance.

2 REPLIES
Cisco Employee

Re: How to busyout a channel on a certain PRI and timout setting

You can busyout the channels on pri line using "isdn busy dsl x b_channel 1-24" under the d channel config (interface serial y:23) where x is the dsl number for that line and 1-24 is the range of channels..That command will busyout those channels from AS5400 side..

Now if the connection got disconnected in about 2 mins then it is mostly because of idle-timeout...which is default to two mins..Here is the link which explains it in detail with solution too.

http://www.cisco.com/warp/public/471/idle_timeout.html

New Member

Re: How to busyout a channel on a certain PRI and timout setting

thank you,

it worked!

311
Views
0
Helpful
2
Replies
CreatePlease to create content