I have a cisco 1605 R series router with ios 12.0 installed. I have my eth 0 connected to my lan switch and my eth1 is connected to my cable modem. i would like to know how to configure with a dhcp to my cable isp. I think in newer versions of ios you can go to the interface config and type the following : "ip address dhcp" but in my interface i don't see this command. My question is how can i configure with my modem
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...