Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to capture switch config from Hyperterminal

Hi!!! I tried to capture configuration reports of a switch which i did from Hyperterminal.I went to the menu bar which in the top and went to transfer ,on the dropdown it says capture text.I did that but when i opened the captured file i can see the text scattered here and there.Is is possible to see the captured configurations of the switch as how we see organised in the hyperterminal.Can u pls tell me ,do i need to do any configurations in the hyperterminal before i could start capture text.

thanks and regards

3 REPLIES

Re: How to capture switch config from Hyperterminal

hi

try opening the file either with wordpad or notepad.

sometimes it works fine with wordpad not though with notepad..

regds

Community Member

Re: How to capture switch config from Hyperterminal

If you open the file using notepad it tends to scatter the text. Have you tried veiwing the file using wordpad instead?

Community Member

Re: How to capture switch config from Hyperterminal

on the hyperTerm

go to tranf

capture and give your file a location ex:c:\temp\test.txt and then hit the start button.

do a sh run on device.

741
Views
0
Helpful
3
Replies
CreatePlease to create content