I was just wondering if it is possible to cascade two (or more) 2948G-L3 switches together so that I get a single switch with 48+48 Fastethernet ports. If yes, can anyone pls tell me how ? Thanks already.
The fastest connection you will be able to get on these switches is to put 2 1000BaseT gbic's into them and connect these with straight 8 wire patch leads. Setup a etherchannel on both switches for the GBIC ports and you connected them on a 2Gbps channel. Do make sure that you set the ports for FULL duplex, no portfast, flowcontrol, 1 switch is source and 1switch is destination. Make sure you use the command line to set it up and when the 2948 supports this use the following command on the ports:
It all depends what you want to achieve. Redundancy can also be achieved on 100Mbit you don't need to use Gbit for that. So you will need to sit down and see where the bulk of your traffic is going and put the gbic's to work there.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.