Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

How to clear "interface" counters

In viewing logs on each of my Catalyst 3500XL Switches I see several Input errors, collisions, CRCerrors, etc. I would like to reset all of the counters and watch what is happening. Any assistance available?!

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: How to clear "interface" counters

Entering the "clear counters" command in enable mode will clear the counters on all the interfaces. You can also specify which counters you want to clear by entering the "clear int counters " Hope this helps..

- Matt

2 REPLIES
New Member

Re: How to clear "interface" counters

Entering the "clear counters" command in enable mode will clear the counters on all the interfaces. You can also specify which counters you want to clear by entering the "clear int counters " Hope this helps..

- Matt

New Member

Re: How to clear "interface" counters

Thank you Matt! I was trying just the "clear" command with a ? for additional commands. Just for your FYI....I am doing this in an attempt to determin why some of my workstations are obtaining an Invalid Subnet Mask when the IP Lease is renewing.

Thanks again!

1810
Views
0
Helpful
2
Replies
CreatePlease to create content