Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

how to config 2948G l3 to 4003 with mutli-vlans

i have a 2948g l3 with 20 vlans,no gbic interface,

on 4003 have same numbers vlan,

how can i config 2948G l3 only use one port(etc F48) to 4003,and all vlans can

link ok?

2 REPLIES
New Member

Re: how to config 2948G l3 to 4003 with mutli-vlans

Cisco Employee

Re: how to config 2948G l3 to 4003 with mutli-vlans

The 2948G-L3 does not support VLANs and you'll need to use bridge-groups instead. You can configure the connectioon between the L3 and 4003 to be a dot1q trunk and configure sub-interfaces for every VLAN you have. The following page should get you started for L3 configs

http://www.cisco.com/warp/public/473/29.html

177
Views
0
Helpful
2
Replies
CreatePlease to create content