10-25-2002 05:57 AM - edited 03-02-2019 02:23 AM
i have a 2948g l3 with 20 vlans,no gbic interface,
on 4003 have same numbers vlan,
how can i config 2948G l3 only use one port(etc F48) to 4003,and all vlans can
link ok?
10-25-2002 07:36 AM
if I understand your question, the best would be to use 802.1Q trunk
for 2948GL3
for 4003
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/7_4/config/e_trunk.htm
regards
Mirek
10-27-2002 09:21 AM
The 2948G-L3 does not support VLANs and you'll need to use bridge-groups instead. You can configure the connectioon between the L3 and 4003 to be a dot1q trunk and configure sub-interfaces for every VLAN you have. The following page should get you started for L3 configs
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide