I have a Cat5009 switch.I don't know how to config a syslog server on the switch.I searched and found a command(set logging server....),but I can't find this command on my Cat5009,maybe the OS ver is too old.
shqdcn-s> (enable) set ?
Set commands:
------------------------------------------------------------------------
set alias Set alias for command
set arp Set ARP table entry
set bridge Set bridge, use 'set bridge' for more info
set cam Set CAM table entry
set cdp Set cdp, use 'set cdp help' for more info
set enablepass Set privilege mode password
set fddi Set FDDI, use 'set fddi' for more info
set help Show this message
set interface Set network interface configuration
set ip Set IP, use 'set ip help' for more info
set length Set number of lines in display (0 to disable 'more')
set logout Set number of minutes before automatic logout
set module Set module, use 'set module help' for more info
set password Set console password
set port Set port, use 'set port help' for more info
set prompt Set prompt
set snmp Set SNMP, use 'set snmp help' for more info
set span Set switch port analyzer
set spantree Set spantree, use 'set spantree help' for more info
set system Set system, use 'set system help' for more info
set time Set time
set trunk Set trunk ports
set vlan Set Virtual LAN information
set vtp Set Virtual Trunk Information
shqdcn-s> (enable)
How can I do ?