Re: How to config the vlan routing when there were to 3 layer sw
In my network there were two 3 layer vlan routing switch (3550-48emi and intel 550t) and three intel 510t and one 2924 layer 2 switches, because 550t has limited layer three function ,so I want to config 3550 as the single layer 3 routing device , I config a 4 port 8021q trunk between 3550 and inter switch stack, and one 4 port trunk to 2924 , but the intel stack can work with 3550 vlan routing ,the another part between 2924 working correctly.
1) i setup a single vtp domain to change vlan informations between the switchs, 3550 as the vtp domain server ,others as vtp client mode to receives vlan imformations from 3550, Does this type setup can take effect?
2) would you tell me vtp can change informations between different vendor's products
3)whether the network can working correctly?
if if can be setup as the this , where my problem could be?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.