Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
474
Views
0
Helpful
1
Replies

How to configure a Cat 5500 switch

robin.mcdonald
Level 1
Level 1

‎08-20-2001 07:29 AM - edited ‎03-01-2019 06:45 PM

I need to configure a Vlan (151) to route to a PIX via a port on the switch. How do I go about doing this.

Labels:
0 Helpful
1 Reply 1

millerv
Level 1
Level 1

‎10-02-2001 03:05 PM

Where is your routing (layer 3 switching ) being done

If its an RSM, you just need to define that vlan on the rsm

then, configure a switchport for vlan151, set the speed and connect the pix.

put the inside interface of the pix in the same subnet as the vlan on the rsm.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents