Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to configure a Cat 5500 switch

I need to configure a Vlan (151) to route to a PIX via a port on the switch. How do I go about doing this.

1 REPLY
Community Member

Re: How to configure a Cat 5500 switch

Where is your routing (layer 3 switching ) being done

If its an RSM, you just need to define that vlan on the rsm

then, configure a switchport for vlan151, set the speed and connect the pix.

put the inside interface of the pix in the same subnet as the vlan on the rsm.

232
Views
0
Helpful
1
Replies
CreatePlease to create content