Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure a layer3-LAn with a mix of vendors

Hi there,

We have a number of cabletron Smartwitches6000 (04 ) & 3Com 3300 switches (03) in a Flat LAN network. We already bought in two new 4006 with L3-routing module WS-X4232-L3 to be stationed as the Cores.

My question is how do I configure Cisco 4006 as the Lay3-core with regading STP, VLAN, VTP, Trunk Etc...

Does anybody expereince with this kind of configation and please advise me the bet solution for this !

have a good day

1 REPLY

Re: How to configure a layer3-LAn with a mix of vendors

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

96
Views
0
Helpful
1
Replies