05-22-2006 11:28 PM - edited 03-03-2019 03:19 AM
hello,
i have a switch running catos4232(modular No.WS4232 L3),now i only enter into the mode of L3Switch4232(config)# using a ip address,i want to configure a Mgnt IP address on switch now so that i can enter into this mode console>(enable),how do i configure it?
thank you!
05-22-2006 11:40 PM
Hi
u can try like this
set int sc0
Thanks
Mahmood
05-23-2006 01:16 AM
Hi,Mahmood,
it seems that "set int sc0
but now i can only enter into the mode of L3Switch4232(config)#
when i entered the command like this L3Switch4232(config)#set int sc0 105 192.168.5.5 255.255.255.0
% Invalid input detected at '^' marker.
i think the set command shoud be only used in the mode of console>(enable)
Thanks
Minquan
05-23-2006 01:35 AM
Hi Minquan,
I don't think thats possible from management interface of 4232 L3 blade.
To access the sup engine prompt can you try to console into the switch from the console port on supervisor engine and assign an ip address.
Regards,
Ankur
05-23-2006 02:04 AM
Hi Ankur
Thanks for your reponse.
I am seeking a console line!
Kind Regards!
Minquan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide