Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to configure frame-relay svc

Using router 2522 as a frame-relay switch, I want to setup svc connections.

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: how to configure frame-relay svc

frame-relay svc

To enable Frame Relay SVC operation on the specified interface, use the frame-relay svc interface configuration command. To disable SVC operation on the specified interface, use the no form of this command

frame-relay svc

no frame-relay svc

Syntax Description

This command has no keywords and arguments.

Default

Disabled

Command Mode

Interface configuration

Usage Guidelines

This command first appeared in Cisco IOS Release 11.2.

SVC operation can be enabled at the interface level only. Once it is enabled at the interface level, it is enabled on all subinterfaces on the interface. One signaling channel, DLCI 0, is set up for the interface, and all SVCs are controlled from the physical interface.

The first use of this command on the router starts all SVC-related processes on the router. If they are already up and running because SVCs are enabled on another interface, no additional action is taken. These processes are not removed once they are created.

Example

The following example enables Frame Relay SVC operation on serial interface 0 and starts SVC-related processes on the router:

interface serial 0

ip address 172.16.3.5 255.255.255.0

encapsulation frame-relay

frame-relay lmi-type q933a

frame-relay svc

314
Views
0
Helpful
1
Replies
This widget could not be displayed.