You are changing the config on a router (Terminal Server). We just added a new MCU connection in Virginia You want telnet to go through line14 on the router. You want to give it the address of 128._._._ You put the description on the interface of Line14, now it is time to assign the IP address. What is the command line to assign an IP address to Line14.
Hint: it is not the same as adding an IP address to S0 or E0.
WHY do we need to assign an ip address on the line.
You can access that line with the reverse telnet using the port number 2014
You can use any ip address which is configured on terminal server let it be any ip address on any physical port or loopback ip address and use port number 2014 to access the device connected to that line.
in addition to Ankur´s post, I assume this is some sort of exam question ?
Judging from the ´hint´, what they are looking for might be:
ip host Router16 2014 128.x.x.x
With this configuration, you can reach the device (I named it Router16, it might be different in your case) directly from a PC or another router. If you Telnet to 128.x.x.x 2014 from your PC or another device, this tells the Telnet client to go to port 2016 instead of the default Telnet port 23. Be aware though that an interface with IP address 128.x.x.x must be configured on your terminal server...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...