cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
759
Views
0
Helpful
2
Replies

How to configure RADIUS authentication in catalyst switch 3548?

expantaiwan
Level 1
Level 1

Hi,

I am trying to configure RADIUS authentication in catalyst switch 3548. but.. when i tried to configure AAA server-group with the command "aaa group server radius MyRADIUS", i cannot designate any IP address to the specific RADIUS server named "MyRADIUS".

Does it mean the 3548 cannot support RADIUS? (PS. the software version is

12.0(5.4)WC(1).....) thanks!!^^

2 Replies 2

DALE FRANCIS
Level 3
Level 3

Hi,

You can definately configure it for RADIUS if you run 12.0(5)WC5.

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc5/ol256201.htm#xtocid14

in order to attach IP to radius server use the following GLOBAL commands.

radius-server host x.x.x.x auth-port zzzz key yyyyy this will configure for authorisation for accouting use the acct-port keyword instead of auth-port or use both as such:

host x.x.x.x auth-port zzzz key yyyyy

host x.x.x.x act-port zzzz key yyyyy

Or if you using all defaults then radius-server host xxxxxx

Regards

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: