Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure rcp on routers ?

hi all,

routers have "ip rcmd" to configure rcp and rsh. And we will do "rsh", "rcp" in

enable mode with router. How to configure the both routers one rsh server and another rsh clinet to execute rsh or rcp between routers.

best regards

fred.

1 REPLY
Silver

Re: How to configure rcp on routers ?

Hello Fred,

From a Cisco Documentation, "To enable the router to act as an rsh server, issue the 'ip rcmd rsh-enable' global configuration command. To enable the router to act as an rcp server, enter the 'ip rcmd rcp-enable' command. The router cannot act as a server for either of these protocols unless you explicitly enable the capacity".

Look at these Cisco documentation for more information.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087c7f.html

http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800ca553.html#xtocid1602111

199
Views
0
Helpful
1
Replies
CreatePlease to create content