Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to configure RME 3.5 to use SSH

Hi,

On LMS 2.2, i tried to configure RME 3.5 to interact with Catalyst 6500 native IOS 12.1(19)E1a with SSH support (k2 image).

It doesn't seem to work. Has anybody already done it ? If so, can you help me to configure it ? Where should i configure the SSH keys on RME ?

SSH is working properly on Catalyst when I use any SSH client.

Thanks for your help.

2 REPLIES
Blue

Re: How to configure RME 3.5 to use SSH

RME->Administration->Config Management->General Setup, move the SSH to the top of the list. Also, in the same screen, for Config Job Setup, select the Transport Tab and move SSH to the top of the list for both config Fetch and Download.

New Member

Re: How to configure RME 3.5 to use SSH

Hi,

thanks for your reply

I've tried all this but it doesn't work, when i try for example to change any interface's description on a switch, the Job fails saying that he couldn't establish a SSH session with the device.

Also i see that RME continues to use TFTP to archive the device's configuration.

what about the public and private keys ??? where can i configure them ???

best,

Anas.

105
Views
0
Helpful
2
Replies
CreatePlease login to create content