Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to configure router in bridge mode

Hi

I have 2 cisco 2621 series routers to be configured in bridge mode.

i'll be connecting this 2 routers using serial connection 128 lease line.

the problem is im not sure how to configure this 2 routers in bridge mode.

as far as i know, i need to issue the command no ip routing.

is there anything else i need to do?

can anyone guide me on how to configure

the router in bridge mode? is there any support page for this is cisco website?

thanks

Jega

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to configure router in bridge mode

Please check the link to the configuration guide below. It describes how to configure transparent bridging.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800ca65a.html

Regards,

Leo

2 REPLIES

Re: How to configure router in bridge mode

Please check the link to the configuration guide below. It describes how to configure transparent bridging.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800ca65a.html

Regards,

Leo

New Member

Re: How to configure router in bridge mode

Hi Friend

Thank you so much for your immediate reply.

I managed to find some clear guide on configuring routers in bridge mode. really appreciate your help

your solution did helped me.

Regards

Jega

1626
Views
0
Helpful
2
Replies
CreatePlease to create content