Re: How to connect 2Mbit fiber to a Cisco2611 router?
What type of link is it between the 2 sites. Is it a fiber existing between the 2 sites or are you buying a link to a service provider ? If you are going through a service provider, what type of service is he providing (E1, ...). Anyway, there are no fiber modules existing for the 2600. Depending on the type of link used, you could always try to use media convertors (E.g. fiber to UTP).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...