If i go to PC B & C and and say Ipconfig i get ip thro dhcp in 10.100.100.x range where this range DHCP Scope is configured in the Sunfire V120-Appgate Server(10.100.100.1 interface) and works fine with all authentication.
Now if i go to PC A as shown in the Slide and say IP config.I want to get the ip config result in the same series of IP: 10.100.100.x
I do i do that,Do in need to create any vlans in HP procurve 2650 and trunk between 4108Gl and HP 2626.
Pls explain with basic steps i need to do for communication to happen between hp 2650 and hp 2626.Pls send me sample configuration with all basic steps.
Is configuring the switch thro web interface and CLI interface is same or only limited utilities with web interface
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...