Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to control access (based on IP) to http server on Catalyst 4006?

How to control access (based on IP) to http server on Catalyst 4006?

2 REPLIES
New Member

Re: How to control access (based on IP) to http server on Cataly

apply an ACL to the SC0 default gatway(s).

Permit HTTP, SNMP, Telnet, etc to SC0

deny all else to SC0

permit Any any

You can't filter layer 3 information on a layer 2 device.

New Member

Re: How to control access (based on IP) to http server on Cataly

Not so.

On CatOS snmp, telnet and ssh is possible to control:

set ip permit ip_address [mask] [all | snmp | telnet | ssh]

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/rel7_2/config/ip_perm.htm

But what about http?

Saulius.

134
Views
0
Helpful
2
Replies
CreatePlease to create content