04-14-2002 10:04 PM - edited 03-01-2019 09:17 PM
Apr 12, 2002, 12:54am PST (2.)
HI
i have grouped e1 pri as 1-15 n 16-31 using channel-group command, now i want to use these serial interfaces( serial 1/0:1, serial 1/0:16) as backup dial-out interfaces for my primary LLs, i tried creating a dialer interface for these but i cant associate it with these serial interfaces. wht is the mechanism to use them for dialing out.
can u explain this plz...thanks
Yogi
04-21-2002 05:47 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
04-21-2002 07:00 PM
you should ask your service provider first.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: