04-05-2006 03:57 PM - edited 03-03-2019 02:40 AM
Help
How can I enable dot1x multiple-authentication on 2948G. The image is 8.2(GLX).
Thanks in Advance
Matt
Solved! Go to Solution.
04-06-2006 03:45 PM
I am quoting it (see below) from the link I sent to you in the previous post. Based on that it looks like it's supported on the 2948G switch
The Cisco Catalyst® Operating System (Catalyst OS) Software Version 7.5(1) for the supervisor engine supports the Cisco Catalyst 6500 Series and Cisco Catalyst 4000/4500 Series multilayer switches (including the Cisco Catalyst 2948G, 4912G, and 2980G-A switches).
Pls. rate all helpful posts.
HTH,
Sundar
04-05-2006 07:53 PM
Matt,
AFAIK, dot1x multiple host authentication isn't supported on 2948G switch.
HTH,
Sundar
04-06-2006 09:43 AM
Thanks for the response.
Any other product other than Cat6500 that supports this?
Thanks
Matt
04-06-2006 09:53 AM
Matt,
3550/4500 switches support multi-host feature. There may be more products out there.
Pls. rate helpful posts.
--Sundar
04-06-2006 02:33 PM
Hello Sundar,
Thanks for the response.
Multi-host does not give me what I want. I am looking for set port dot1x mod/port multiple-authentication which will force every mac on the port to undergo dot1x authentication. In the case of Multi-host only one of mac's need to authenticate - all the rest ride in for free.
I did locate a version 8.1 that supported this feature - can you please confirm if this is true.
Thanks
Matt
04-06-2006 03:21 PM
Matt,
Yes, the multiple-authentication feature is supported in 8.1 version. It appears it was introduced in version 7.5(1)as described in the following link.
http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletin09186a0080125da0.html
Pls. rate all helpful posts.
--Sundar
04-06-2006 03:38 PM
Thanks again Sundar
Will it work on 2948G - according to 8.1 Command ref manual it does. Could you please confirm.
Thanks
Matt
04-06-2006 03:45 PM
I am quoting it (see below) from the link I sent to you in the previous post. Based on that it looks like it's supported on the 2948G switch
The Cisco Catalyst® Operating System (Catalyst OS) Software Version 7.5(1) for the supervisor engine supports the Cisco Catalyst 6500 Series and Cisco Catalyst 4000/4500 Series multilayer switches (including the Cisco Catalyst 2948G, 4912G, and 2980G-A switches).
Pls. rate all helpful posts.
HTH,
Sundar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: