Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to enable the TCP protocol and port on Router 1601

Hi,

How can I enable the Protocol and port on 1601 router?

I know to enable UDP protocol and port as following:

Router(config)# IP forward-protocol upd88 (enable protocol UDP and port 88)

Router(config)# IP forward-protocol UDP (enable protocol UDP and all udp port)

I get the problem remote xp workstations - outlook2002 to start (take too long to start about 10 mins or more) I think the router may block some of the kerberos and exchange 2000 authentication protocols.

Thanks,

Dannie

1 REPLY
New Member

Re: How to enable the TCP protocol and port on Router 1601

Hi Dannie:

Your command is right, but do you need it? Did you do an IP packet debug to find out what is happening? You may want to use the "IP helper-address" command instead. Might be quicker.

Thanks...Steve

529
Views
0
Helpful
1
Replies