How to enable the TCP protocol and port on Router 1601

[dannie-chan]

Hi,

How can I enable the Protocol and port on 1601 router?

I know to enable UDP protocol and port as following:

Router(config)# IP forward-protocol upd88 (enable protocol UDP and port 88)

Router(config)# IP forward-protocol UDP (enable protocol UDP and all udp port)

I get the problem remote xp workstations - outlook2002 to start (take too long to start about 10 mins or more) I think the router may block some of the kerberos and exchange 2000 authentication protocols.

Thanks,

Dannie

[scarothe]

Hi Dannie:

Your command is right, but do you need it? Did you do an IP packet debug to find out what is happening? You may want to use the "IP helper-address" command instead. Might be quicker.

Thanks...Steve