Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

How to fix "Can't set restart-delay for this interface" ?

Hi, sir

have 7206VXR:

ROM: System Bootstrap, Version 12.0(19990210:195103) [12.0XE 105], DEVELOPMENT SOFTWARE

BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(10)S, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

Cisco Internetwork Operating System Software

IOS (tm) 7200 Software (C7200-IS56I-M), Version 12.1(15), RELEASE SOFTWARE (fc1)

There is message below when reload:

%SYS-4-CONFIG_NEWER: Configuration from version 12.1 may not be correctly understood

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Can't set restart-delay for this interface

Please kindly tell how to fix ?

Thank you.

1 REPLY
Cisco Employee

Re: How to fix "Can't set restart-delay for this interface" ?

The serial restart-delay will allow the user to set the amount of time the router

will wait before re-trying to bring up a serial interface. If the default value of the

restart-delay is 0 then user is not allowed to change that value. That is why in

this case you were getting the message. It is normal and should not affect the router

355
Views
0
Helpful
1
Replies
CreatePlease to create content