I had 48 modems on an AS5300 but only one PRI. I had outgoing DDR configured for both ISDN and analog calls and incoming RAS service for analog. It worked good.
Now I added a second PRI under a different phone number. The modems for these connections needed a different configuration so I used modem pools to direct calls to the correct modems based on called number DNIS. It though it was working good, at least it was for incoming calls.
The problem is that the outgoing analog calls seem to be rotating between the two PRIs. If it goes out the old one it works. If it tries to go out the new one it fails because the telco service behind that circuit is not set up to take inbound (from their perspectived) calls.
How do I bind the outgoing calls to one PRI? I am using a dialer interface for the outgoing calls.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.