Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to generate LABP Disconnect on a router

For technical training we need a to force a "clean" LAPB Disconnect. How do we force such normal clean on a Cisco 2611 with a X.25 connection to a X.25 Switch ?

With "int s0/0, shutdown", the router simply put the RTS Signal OFF. And I didn't found any clear command that force a LABP Disconnect message to be send.

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: How to generate LABP Disconnect on a router

With an X25 interface, the best that you

can do is to clear the X25 interface or VC

which will cause a RESATART to be sent at

the X25 layer. There isn't a way to generate

any LAPB DISCONNECT frame via the exec

CLI.

232
Views
0
Helpful
1
Replies
This widget could not be displayed.