Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to get out of ROMMON mode

Hi ,

I have a remote router its coming in Rommon mode ?

any help

regards

Neo

2 REPLIES
Blue

Re: How to get out of ROMMON mode

for some reason or another, the router was not able to boot its full IOS and has booted into rommon mode.

this could be intentional with setting the configRegister or it could be due to a software failure on your flash/bootflash or a phyical problem with the device.

you may need to get an IOS on the device so it can boot fully.

see the link below for info on the rommon recovery procedure, which will show you how to get the router to boot normally:

1700 routers -

http://www.cisco.com/en/US/products/hw/routers/ps221/products_tech_note09186a00800942dc.shtml

2600 routers -

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a0080094a0b.shtml

1600 routers -

http://www.cisco.com/en/US/products/hw/routers/ps214/products_tech_note09186a0080094013.shtml

there are many different links for the different router models. goto cisco.com and search for 'rommon recovery' if you don't see your router listed above. (most of these router models have the same process for this task so any of the above docs may work fine)

New Member

Re: How to get out of ROMMON mode

WS-X4012 always boots into ROM Monitor,I tried to boot it up with some documents listed in WWW.CISCO.COM,but it's no use.How can I boot it up?

12446
Views
5
Helpful
2
Replies
CreatePlease login to create content