I am in a big problem Well we have Cisco Catalyst 2950 switch. I have to write a application which will automatically fill up the database with the ports information from the switch (the switch can be any Cisco Switch but presently its Catalyst 2950 switch). The documentation says that I can get all the ports information from .iso.org.dod.internet.mgmt.mib-2.dot1dBridge.dot1dBase.dot1dBasePortTable now when I walk through this OID it gives me information about only the Active ports in the switch. I.e. for the ports which is connected to some computer but I need to get all the ports with their information. .iso.org.dod.internet.mgmt.mib-2.interfaces.ifTable wont do as it gives the interfaces from the switch and I need to get the ports information.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...