Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

how to implement "microcode reload" via snmp command?

Sometimes I need to perform a "microcode reload" command on my 12012 router ,and now i wanna do this via snmp,by here I don't know the corresponding snmp MIB OID.

I know this task is quite simple on normail router interface,just using snmpset to change ifAdminStatus value,

But here i don't know what MIB value I should use to perform "microcode reload",who have experience before?

TIA!

1 REPLY
Blue

Re: how to implement "microcode reload" via snmp command?

I don't think that there's a specific MIB object for the above.

140
Views
0
Helpful
1
Replies
CreatePlease to create content