Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to load balance two link (resilient link)

How to load balance (if can) or failover two Fiber channel like as below?

interface GigabitEthernet0/1

switchport mode trunk

channel-group 1 mode active

channel-protocol lacp

!

interface GigabitEthernet0/2

switchport mode trunk

channel-group 1 mode active

channel-protocol lacp

1 REPLY
New Member

Re: How to load balance two link (resilient link)

Hi

You can use this "port-channel load-balance src-dst-ip", this will do a XOR on source & destination IP addresses and choose the interface G0/1 if the first bit of the result is 0 or the interface G0/2 if the first bit of the result is 1.

But you can check the path used with that command: "sh etherchannel 1 port-channel"

You can load balance with the mac-addresses too (it is the default mode I think)

http://www.cisco.com/warp/public/473/4.html

Rate if it helps.

MB

246
Views
4
Helpful
1
Replies