Hi, is there anyway to measure how many percent the utlization of the interface ?, for instance to measure the utilization of the serial interface which is connected to the leased line so it can help to make a decision whether to upgrade to faster line or to keep it that way
For this case,you install a third party free monitoring software like the MRTG,it will show you the utlization of the interface within a period.Otherwise,using the "show interface serial "command,you check the load of interface ?/255
When you do a show interface command on the router you will get a 5 min input and output rate - these combined will give you an approx value. - Obviously this is only a snapshot but ok as a ready reackoner.
Another way would be to use a decent network monitoring tool to interegate the router.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.