Re: How to MLPPP over 2 Serial T1 interface on a 2600 router wit
Possible, yes. Recommended, no. When dealing with just two t1's it really not recommended to the the overhead that is required tun ppp multilink. It would be better to just load balance on a per packet basis by turning off fast-switching (no ip route-cache on interface). But if you still want to run ppp multilink then here is the link that shows you how to do it using virtual-templates. You can also use multilink intefaces.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...