Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to place switches in spanning tree debug mode

Hello everyone

I have been unable to place a few switches in spanning-tree debug mode using the debug spanning-tree events. The command gets returned as invalid input in priviliged EXEC mode. In other modes it is retured as an unrecognized command. I looked into the configuration of the spanning tree in the show spanning-tree output and it seems all fine. Please advise me how to enable this debugging functionality.

Thank you for reading,

Dee

  • Other Network Infrastructure Subjects
2 REPLIES
Bronze

Re: How to place switches in spanning tree debug mode

Use the debug spanning-tree privileged EXEC command to debug spanning-tree activities. Use the no form of this command to disable debugging output.

debug spanning-tree {all | backbonefast | bpdu | bpdu-opt | config | csuf | etherchannel | events | exceptions | general | mstp | pvst+ | root | snmp | switch | uplinkfast}

no debug spanning-tree {all | backbonefast | bpdu | bpdu-opt | config | csuf | etherchannel | events | exceptions | general | mstp | pvst+ | root | snmp | switch | uplinkfast}

To view the syntax description click this link.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2940/software/release/12.1_13_ay/command/reference/debug.html#wp1029961

Re: How to place switches in spanning tree debug mode

Hi ,

Check out the belwo link hoep that helps out your query !!

http://comet.lehman.cuny.edu/griffeth/classes/Spring05/Homeworks/Manual.pdf

Regards

Ganesh.H

3971
Views
0
Helpful
2
Replies