11-15-2001 01:48 AM - edited 03-01-2019 07:23 PM
Is it possible to use my 4T Netowrk Module to provide cumulatively above 4MB or =4MB of data rate to a client of mine.
In a support page i have come accross where i can realise my 4T module to provide 8MB data rate.
If so , is it possible to provide 4MB and still use my other modules for other links.
11-22-2001 09:31 PM
hi,
It is possible to take 4mb from a single port.
I am not sure which port. It is either port2 or port3 on the nm-4t module.
you can use the other ports for other links.
But i think you will not be able to use the 4th port which is for 8mb.
11-26-2001 12:09 PM
hi kvc...thanks for replying
Can u gimme a hint as to how will i be able to do it....some hardware changes or through command line only.....i mean by just adding something to the config thru command line.
11-28-2001 11:13 PM
hi,
There are no config changes required.
In NM-4T card if i use the fourth port only and all other ports are not being used then i can derive full
8mb from that port.
If i am using the third port and no other port
then i can use 4mb from it. If i use the 2nd and 1st port also then i get 2mb for 1st and 2mb for second port also. In altogether 4+2+2.( but in this case you cannot use the 4th port).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide