Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to recover 6500 in native ios mode from rommon

how to recover 6500 in native ios mode from rommon the image uploaded has a bad checksum now it has crashed if i upgraded from xmodem will it work???

when i issue boot slot0: it says device magic number and gives some error what could be the reason i copied the image from my laptop to the flash disk

Regards

2 REPLIES
Bronze

Re: how to recover 6500 in native ios mode from rommon

The xmodem option is not available for the CAT6000/6500 platform. Here are the instructions on recovering from ROMMON mode.

http://www.cisco.com/warp/public/473/124.html

Cisco Employee

Re: how to recover 6500 in native ios mode from rommon

This document is helpful for recovering a 6500 switch with Native IOS from a corrupted image:

http://www.cisco.com/warp/customer/473/14.html

The xmodem procedure is supported and detailed in the above doc.

710
Views
0
Helpful
2
Replies