05-30-2002 10:39 AM - edited 03-01-2019 09:57 PM
What command is used to remove a port channel that was setup on a 6509? I believe that it is done by the command "set port channel 2/16 mode off". After running this command I used "show channel" - 2/16 no longer appears. However, after running the "show config" command there is an output line stating "set port channel 2/16 mode off".
05-31-2002 03:58 AM
Hi,
Yes I have experienced this too - we scrapped the config and started from scratch !
I eagerly await the answer too!
06-02-2002 02:34 PM
The default channel mode is auto and "off" is one of the configurable channel modes. Try"set port channel 2/16 mode auto" and the config under module 2 should go away. But still you would see an admin group assigned under #port channel.
If you do not wish to channel, the best pratice is to set the channel mode to off.
Regards,
-Prashanth
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: