What command is used to remove a port channel that was setup on a 6509? I believe that it is done by the command "set port channel 2/16 mode off". After running this command I used "show channel" - 2/16 no longer appears. However, after running the "show config" command there is an output line stating "set port channel 2/16 mode off".
The default channel mode is auto and "off" is one of the configurable channel modes. Try"set port channel 2/16 mode auto" and the config under module 2 should go away. But still you would see an admin group assigned under #port channel.
If you do not wish to channel, the best pratice is to set the channel mode to off.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...