cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6022
Views
0
Helpful
5
Replies

How to replace failed supervisor module IV on Cisco WS-C4506

shaunjabrook
Level 1
Level 1

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(25)EWA5. Cisco has RMA a new supervisor module. Please advise what are the steps to replace a failed sup mod

5 Replies 5

dnewell24
Level 1
Level 1

Installing and Removing the Supervisor Engine for Catalyst 4500

http://www.cisco.com/en/US/products/hw/switches/ps4324/prod_installation_guides_list.html

Scroll down to the Supervisor Engine Notes section and locate your supervisor model.

Prashanth Krishnappa
Cisco Employee
Cisco Employee

If you have compact flash card, back up the configs and IOS to the flash card. Swap out the Supervisor, use the IOS and config on the compact flash card to boot the new Supervisor.

PS: Remember to rate useful posts.

Good point..

To be clear on my side - as i have never replaced a failed sup module before - i would take the following steps - i do have about 122 mb free on slot0:

copy bootflash: slot0:

cat4000-i5s-mz.122-25.EWA5.bin

copy bootflash: slot0:

running-config

Then - I should be able to hotswap the failed sup module with the new one.

copy slot0: bootflash:

cat4000-i5s-mz.122-25.EWA5.bin

copy slot0: bootflash:

running-config

Verify

Please advice - thanks

Hi Friend,

AFAIK to copy image from bootflash to slot0 and vice versa is ok but to copy config you muct run the command

copy config slot0:

and for putting it back

copy slot0: config

Check this link

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/8_1/cmd_ref/cl_t_ses.htm#1062281

HTH, if yes please rate the post.

Ankur

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco