Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

how to run network show commands

I have created a batch reports (in RME) with certain show commands, and I have selected a catlyst 6009 switch as device, but when I try to generate this report it gives a error message as incorrect telnet password.

Do I have to define this password in RME somewhere or is it something to be defined on the catalyst itself.

Can some one pls help on this? Thx in advance.

javed

1 REPLY
New Member

Re: how to run network show commands

In RME administration change the attributes for your switch. You can manually define SMNP strings and passwords.

132
Views
0
Helpful
1
Replies
CreatePlease to create content