01-27-2006 02:12 PM - edited 03-03-2019 01:36 AM
I'm upgrading a 6500 with dual Sup2. Have copied the new boot image and system image to both bootflash and slavebootflash. Have also set new boot statements for the active Sup.
However couldn't set the boot variables for the standby Sup. Do I need to? Will the boot statements in the startup config take care both Sup's?
Thanks
Gary
01-27-2006 03:49 PM
If you do a wr mem, it should synchronize. You can verify using sh bootvar. Here is outputs from my lab
Router#sh bootvar
BOOT variable = sup-bootflash:c6sup22-jsv-mz.121-26.E3,1
CONFIG_FILE variable =
BOOTLDR variable =
Configuration register is 0x2102
Standby is up
Standby has 227328K/34816K bytes of memory.
Standby BOOT variable = sup-bootflash:c6sup22-jsv-mz.121-26.E3,1
Standby CONFIG_FILE variable =
Standby BOOTLDR variable =
Standby Configuration register is 0x2102
01-30-2006 06:25 AM
I have copied running config to startup, but when I did sh bootvar, I could only see the firt half of your output till "....0x2102", but not the 2nd half where it showed the standby information.
Any suggestion? Thanks
Gary
01-30-2006 07:15 AM
Please check wheter the sup's are really synchronized. The following URL contains a lot of info on the subject:
Regards,
Leo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: