Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to set dot1q trunk between 2900xl and Foundry FastIron switch

I have a 2900XL, FX prot 23 set with

swithport mode trunk

switchport trunk encap dot1q

Its connected to a Foundry Fastiron Backbone( 16 FX ports, 100M)

How do I set the a port on foundry box to use dot1q ?

2 REPLIES
New Member

Re: How to set dot1q trunk between 2900xl and Foundry FastIron s

the default encapsulation in the Foundry is dot1q,so you just type :

vlan *

tag e16

New Member

Re: How to set dot1q trunk between 2900xl and Foundry FastIron s

Thanks for your reply

The foundry switch in question, is discontinued product.It is a Fast Iron Backbone with 16 100M Fx ports.

I some how acquired the latest upgrade code

(7.1) but the documentation on the Foundry wesite does not seem to apply ( e.g the

FastIron(config)cdp run --> command does not work witht he new code)

So my qustion is does the switch still by default had dot 1q ?

How can I confirm ?

The commands you have suggessted "vlan *"

will only allows me to configure a port with that particular vlan. Then the Cisco device fed from the founundy trunk port will not allow more than one vlan.

I have to set multiple vlans on the end cisco device ?

291
Views
0
Helpful
2
Replies